View Single Post
  #18  
Old October 25th, 2007, 07:53 AM
ca_surveyor
 
Posts: n/a
I have a Mallory

I have been running a Mallory for about two years on my 4.6 88' RRC. Parts are normally available at larger speed shops that carry Mallory.

I did and still feel that the tuning has been an ongoing issue, related to unexpected pings from time to time. Possibly related to the mech. curve. I might start playing with different springs. It does have an adjustable vacuum (via screw in pod). My first pod was bad and was causing full vacuum in excess of 50 degrees.

I went with the AB setup (expensive) and had to purchase a coil elsewhere. On several sites I have seen how you can remove your old gear and add it to a Mallory from Summit, etc. Installation is easy and can be done in less than an hour (including the rewiring).

Good luck.
Reply With Quote