SlickRock Fabrication Disco2 ABS Extension Kit

SlickRock Fabrication Disco2 ABS Extension Kit (ABS) $145

Quantity Add to cart

If your particular suspension set-up on your Disco2 has enough travel to yank on the ABS wires, fit the SlickRock Fabrication Disco2 ABS Extension Kit. This kit contains four extensions to extend the four ABS wires at all four corners of your Disco2. The components are made by WABCO, the makers of the ABS system on the Disco2 and numerous other vehicles. The extensions are plug and play, and there is no vehicle butchery required to fit the extensions.

SlickRock Fabrication Disco2 Front Swaybar Disconnects

SlickRock Fabrication Disco2 Front Swaybar Disconnects (D2DISCONNECT) $195

Quantity Add to cart

The SlickRock Fabrication Disco2 Front Swaybar Disconnects are adjustable for length so that you can accommodate side-to-side variations in your Disco2's front suspension. The Disconnects are very easily installed. To disconnect them from the axle, remove the click pin and remove the pin from the axle housing. The Disconnects may then be swung upward and quickly attached (using the same click pin that secures the Disconnects to the axle) to the retaining sleeves that are bolted to your vehicle's chassis. With the Disconnects secured to the vehicle's chassis, the front swaybar will not float about after disconnection. The Disconnects' joints are greaseable through the zerk fittings. For the front of the Disco2, and not for the rear.

 

SlickRock Fabrication Disco2 ABS Extension Kit

If your particular suspension set-up on your Disco2 has enough travel to yank on the ABS wires, fit the SlickRock Fabrication Disco2 ABS Extension Kit. This kit contains four extensions to extend the four ABS wires at all four corners of your Disco2.

SlickRock Fabrication Disco2 ABS Extension Kit SlickRock Fabrication Disco2 ABS Extension Kit

The components are made by WABCO, the makers of the ABS system on the Disco2 and numerous other vehicles. The extensions are plug and play, and there is no vehicle butchery required to fit the extensions.

SlickRock Fabrication Disco2 Front Swaybar Disconnects

The SlickRock Fabrication Disco2 Front Swaybar Disconnects are adjustable for length so that you can accommodate side-to-side variations in your Disco2's front suspension. The Disconnects are very easily installed. To disconnect them from the axle, remove the click pin and remove the pin from the axle housing. The Disconnects may then be swung upward and quickly attached (using the same click pin that secures the Disconnects to the axle) to the retaining sleeves that are bolted to your vehicle's chassis. With the Disconnects secured to the vehicle's chassis, the front swaybar will not float about after disconnection. The Disconnects' joints are greaseable through the zerk fittings. For the front of the Disco2, and not for the rear.

SlickRock Fabrication Disco2 Front Swaybar Disconnects

The click pin is very easily removed without tools, and yet it is secure in place during use.

SlickRock Fabrication Disco2 Front Swaybar Disconnects

To remove the click pin, simply hinge open the retaining ring and pull out the pin. To install the click pin, simply insert it and then flip over the retaining pin. It really is that easy.